Radiolink R12DSM/ R12DS/ R9DS/ R8FM/ R8EF/ R8SM/R8XM/ R8FG/R8FGH/R7FG/

Radiolink R9DS RC Receiver 9 Channels Information Ransmission SBUS/PWM/PPM Signal Compatible AT9 AT9S AT10II AT10 Remote Control

 
 Features: 

【10 Channels】:Support SBUS and PWM signal, while use the SBUS, it can connect 10 channels.
【Double Signal Spread Spectrum】:Radiolink R9DS 10 channels using DSSS and FHSS spectrum anti-interference technology, you don't worry about signal loss.
【Fast Response and Mini Size】: All Channels will response within 3ms, fast and stable. Only 43*24*15mm, just need one cable to connect SBUS, quick to set and play.
【Long Distance Control】:This transmitter receiver can control 900m ground and 1500 air exceptional range. (Actually control range depends on the using environment)
【You Will Get】: an advanced technology receiver and a 12-month warranty from the brand Radiolink and 24-hour friendly customer service.

 
 Please note: 

1.RD9S only work with Radiolink transmitter products: AT9S, AT9,AT10,AT10II.
2.Short push the ID set switch two times within 1 second it can change signal, while the LED change to red, it indicates PWM signal output, the blue/purple LED indicates SBUS signal output.
3.SBUS and PWM signal output, you can use 10 channels.

 
 How to Match Code With Transmitter: 

1. Place the transmitter and the receiver close to each other within 1 meter.
2. Turn on the transmitter, then power on the R9DS.
3. Connect CH3 of R9DS to ESC.
4. There is a black button on the R9DS, use a thin stick or pen press the binding button in one second until the receiver light starts blinking and release, after about 8 times blinking,match code success when receiver signal LED always on.

 
 SBUS and PWM signal change: 

Short press the ID SET switch two times within 1 second, the signal is changed from normal
PWM to SBUS. The red LED indicates the normal PWM and blue/purple LED indicates SBUS signal.

 
 Two signal working mode: 

(1)PWM signal output working mode:red LED indicates PWM signal output, 9 channels Totally.
(2) SBUS signal output working mode: blue/purple LED indicates SBUS signal output, 10 channels totally.
SBUS and PWM signal possible working at the same time with SBUS signal output working mode.
CH9 output SBUS signal, the original CH1 output CH3 and original CH2 to CH6 output CH6 to CH10 PWM signal at the same time.