IFlight BLITZ F745 Stack (BLITZ E55 4IN1 ESC 2-6S）

IFlight BLITZ F745 E55 Stack STM32F745 W/ BLITZ F745 Flight Controller / BLITZ E55 4IN1 ESC 2-6S 30.5mm for RC FPV Racing Drone

• Please download the Ardupilot firmware of the FC from the following link: http://firmware.ardupilot.org/Copter/stable-4.5.5/BlitzMiniF745/

• When using this ESC on a 7-10 inch drone, please add an additional capacitor to prevent overloading the onboard capacitor of the ESC. This precaution will help ensure optimal performance and reliability of your drone's power system.

• Improved circuit design, better components and lower electrical noise!

• DJI HD VTX Connector (Plug-and-Play / No soldering required)

• FC indicator LEDs for visual debugging

• Support Betaflight, INAV, Ardupilot firmware

• MCU: STM32F745

• Gyro: ICM42688

• Barometer: DPS310

• OSD Chip: AT7456E

• Flash: 32MB (Blackbox flash)

• UARTS: 6

• Smartaudio / IRC Tramp VTX protocol supported

• LED controller: Yes

• Beeper pad: Yes

• Mount pattern: 30.5*30.5mm

• Dimensions: 36.5*35 mm

• Weight: 7.8g

• BEC:Output 5V 2.5A continuous output current, 3A peak current (15 seconds)

• Output 9V 2.5A continuous output current, 3A peak current (15 seconds)

• BF Firmware target: IFLIGHT_BLITZ_F7_AIO

• Ardupilot Firmware: arduplane_with_bl

• Wiring Suggestion

• UART 1 for VTX HD / Analog

• UART 2 for a Receiver

• UART 3/4/5 for GPS or other sensors that require a serial port

• UART 6 for ESC Telemet

• Mounting Holes: 30.5*30.5mm/4mm

• Weight: 15.3g

• Supports 2-6S lipo input

• MCU: G071

• Constant: 55 Amps

• Burst: 65 Amps

• Current sensor: Yes

• BEC: No

• Current rate: 200

• Supports: DShot DShot150/300/600/MultiShot/ OneShot etc.

• Target: IFLIGHT_BLITZ_G3 32.9

• 1 x BLITZ F745 V1.2 Flight Controller

• 1 x BLITZ E55 4-IN-1 2-6S ESC

• 1 x silicon grommets

• 1 x wire harness for F7 Flight controller