MATEK MATEKSYS EXPRESSLRS 2.4GHZ PWM VARIO RECEIVER, R24-P6V

MATEK MATEKSYS EXPRESSLRS 2.4GHZ PWM VARIO RECEIVER, R24-P6V 2.4GHz ISM 22.5dbm (180mW) for RC FPV Drone

• ESP32-PICO-D4, SX1281, ExpressLRS Firmware
• PA/LNA: SE2431L
• RF Frequency: 2.4GHz ISM
• Telemetry power: 22.5dbm (180mW)
• Diversity: Antenna-switching, default ANT1
• Barometer SPL06-001 (Vario)
• Receiver output: 6x PWM CH
• VBAT voltage sense: 0~25.5V
• Antenna connector: IPEX MHF-1
• Power supply: 4-13V DC @ "V" Pad
• Power dissipation: 60mA~80mA@5V IN
• PCB size: 30mm x 18mm
• Weight: 4g w/ antenna

• 1x ELRS-R24-P6V
• 2x IPEX MHF1 Antennas. 15cm
• Dupont 2.54 pins (Board is shipped unsoldered)

• ExpressLRS, wiki, Click HERE
• Receiver Target: Generic targets used as a base 2.4 GHz > > Generic ESP32 PWM Vario 2.4Ghz RX
• Receiver has ExpressLRS 3.3.2 preloaded with binding phrase "123456", the Receiver will never enter binding mode if using the traditional binding procedure.
• You need to reflash it with your binding phrase OR connect it to your PC/phone via WiFi and set your binding phrase in WebUI.

• Full Resolution Switch Configuration Modes
• Powering receiver with Reverse Voltage will damage the regulator chip. DOUBLE CHECK the power wires connected to the receiver.

• Power on receiver. Receiver's LED(Red) will blink slow at first, and after 20s, it should blink fast indicating it's on Wifi Hotspot Mode.
• Wifi SSID "ExpressLRS RX", Password "expresslrs"
• More detailed steps, pls refer this page.

• Disconnect ESC and servos from receiver first.
• Wire the receiver into the USB-TTL adapter, with TX on receiver connected to the Rx on the USB-TTL, and RX on receiver connected to the Tx of the USB-TTL. Wire 5V and GND of the USB-TTL to "V" and GND of the Receiver.
• Press the boot button while powering on the receiver, then release – the Red LED on receiver should now be solid on.
• Configurator 1.6.x or newer, Select the target Generic targets used as a base 2.4 GHz –> Generic ESP32 PWM Vario 2.4Ghz RXX and "UART" for Flashing Method, set your bind phrase and Firmware Options , Check "erase before flash" and "Force FLash ".
• Web-flasher https://expresslrs.github.io/web-flasher/