IFlight BLITZ ATF435 Stack (BLITZ E55S 4IN1 ESC 2-6S/ BLITZ 1.6W VTX)
IFlight BLITZ ATF435 Stack (BLITZ E55S 4IN1 ESC 2-6S/ BLITZ 1.6W VTX)
Обычная цена
$27.71 USD
Обычная цена
$0.00 USD
Цена со скидкой
$27.71 USD
В наличии: 369
Количество
Не удалось загрузить сведения о доступности самовывоза
IFlight BLITZ ATF435 Stack ICM42688 32MB Blackbox with BLITZ E55S 4IN1 ESC 2-6S / BLITZ 1.6W VTX for RC FPV Drone
BLITZ ATF435 Flight Controller
- MCU: AT32F435CGU7
- Gyro: ICM42688
- Barometer: DPS310
- OSD Chip: AT7456E
- Flash: 32MB (Blackbox flash)
- UARTS: 6
- Motor outputs: 4x (SH1.0 connector)
- I2C serial: SDA / SLA pads
- Smartaudio / IRC Tramp VTX protocol supported
- LED controller: Yes
- Beeper pad: Yes
- Firmware target: IFLIGHT_BLITZ_ATF435
- Mount pattern: 30.5*30.5mm / 4mm PCB hole diameter
- Dimensions: 36.5*35 mm
- Weight: 7.8g
- BEC: 5V 2.5A / 9V 2A
Wiring Suggestion
- UART 1 for VTX HD / Analog
- UART 2 for a Receiver
- UART 3/4/5 for GPS or other sensors that require a serial port
- UART 6 for ESC Telemet
Packing List
- 1 x BLITZ ATF435 Flight Controller
BLITZ E55S 4-IN-1 ESC
- Mounting Holes: 30.5*30.5mm/Φ4mm
- Weight: 14.7g
- Supports 2-6S lipo input
- MCU: BB21
- Constant: 55 Amps
- Burst: 65 Amps
- Current sensor: Yes
- BEC: No
- Current rate: 200
- Supports: DShot DShot150/300/600/MultiShot/ OneShot etc.
- Target: Q-H-25 16.7(BlheliS) / Bluejay Q-H-50 (Bluejay)
- 1 x BLITZ E55S 4-IN-1 2-6S ESC
- 1 x Power cables & ESC signal wires
BLITZ 1.6W VTX
- Input voltage: 7V～34V
- Interface: MMCX
- Power levels: PIT/25mW/400mW/800mW/1600mW
- Channels: 40 (including Raceband)
- Mounting pattern: 30.5x30.5mm/Φ3
- Lightweight: 18.9g (excluding antenna)
- VTX telemetry: IRC Tramp
- Betaflight IRC Tramp Configuration: Please download the attached VTX table for Betaflight!
- RC Tramp VTX table values: 25mW/400mW/800mW/1600mW
Packing List
- 1 x BLITZ 1.6W VTX
