Holybro Tekko32 F4 Metal 4in1 65A ESC (AM32)

• F4 MCU @150Mhz / Metal-Cased MOSFET / PWM output: 16k ~96k PWM / 4~6S / AM32_Firmware

• The all new Tekko32 Metal is the first 4in1 ESC in the market to adapt the fast F4 MCU. Powerful & reliable metal-cased MOSFET 4in1 ESC with smooth control and quick response.

• New & faster F4 MCU @ 150Mhz (compared to F3 @108Mhz & F0 @48Mhz)

• PWM Frequency: 16k to 96k

• Metal-cased MOSFET for excellent heat dissipation

• Massive on-board capacitance for noise filtering at 2068uf

• 3 oz copper PCB design to allow bigger current and better heat dissipation

• Separate drive & control circuit, this broadens the current capability of the drive circuit while reducing the electrical interference to the control circuit.

• Continuous Current: 65A x4

• Burst Current: 75A x4

• Supports 4-6S battery

• Supports DShot 150/300/600/1200 & MultiShot/OneShot/Proshot/PWM etc.

• ESC telemetry Supported

• Onboard analog current sensor

• No output BEC

• AM32 firmware

• 1000uf 35v capacitor included (highly recommended for 6s setup)

• Amperage meter scale ratio: 180 

• Dimensions: 43 x 44mm / Weight: 15.8g

• Mounting holes: M4 30.5x30.5mm (M3 grommets included)

• Air flow for the ESC is very important if you want to run this 4in1 in high current.

• The battery wire (from Lipo to 4in1 ESC) should be at least 12AWG and well soldered.

Tekko32 F4 Metal 4in1 65A ESC *1
M3 Anti-Vibration Silicone Grommet Insert *4
Electrolytic capacitor: 1000uF 35v *1
8pin to 8pin 1mm pitch 65mm cable *1
8pin to 8pin 1mm pitch 25mm cable *1