IFlight BLITZ F745 Stack (BLITZ E55 4IN1 ESC 2-6S)

IFlight BLITZ F745 E55 Stack STM32F745 W/ BLITZ F745 Flight Controller / BLITZ E55 4IN1 ESC 2-6S 30.5mm for RC FPV Racing Drone

• Please download the Ardupilot firmware of the FC from the following link: http://firmware.ardupilot.org/Copter/stable-4.5.5/BlitzMiniF745/
• When using this ESC on a 7-10 inch drone, please add an additional capacitor to prevent overloading the onboard capacitor of the ESC. This precaution will help ensure optimal performance and reliability of your drone's power system.

• Improved circuit design, better components and lower electrical noise!
• DJI HD VTX Connector (Plug-and-Play / No soldering required)
• FC indicator LEDs for visual debugging
• Support Betaflight, INAV, Ardupilot firmware

• MCU: STM32F745
• Gyro: ICM42688
• Barometer: DPS310
• OSD Chip: AT7456E
• Flash: 32MB (Blackbox flash)
• UARTS: 6
• Smartaudio / IRC Tramp VTX protocol supported
• LED controller: Yes
• Beeper pad: Yes
• Mount pattern: 30.5*30.5mm
• Dimensions: 36.5*35 mm
• Weight: 7.8g
• BEC:Output 5V 2.5A continuous output current, 3A peak current (15 seconds)
• Output 9V 2.5A continuous output current, 3A peak current (15 seconds)
• BF Firmware target: IFLIGHT_BLITZ_F7_AIO
• Ardupilot Firmware: arduplane_with_bl
• Wiring Suggestion
• UART 1 for VTX HD / Analog
• UART 2 for a Receiver
• UART 3/4/5 for GPS or other sensors that require a serial port
• UART 6 for ESC Telemet

• Mounting Holes: 30.5*30.5mm/Φ4mm
• Weight: 14.7g
• Supports 2-6S lipo input
• MCU: BB21
• Constant: 55 Amps 
• Burst: 65 Amps
• Current sensor: Yes
• BEC: No
• Current rate: 200
• Supports: DShot DShot150/300/600/MultiShot/ OneShot etc.
• Target:   Q-H-25 16.7(BlheliS) / Bluejay Q-H-50 (Bluejay)

• 1 x BLITZ F745 V1.2 Flight Controller
• 1 x BLITZ E55S 4-IN-1 2-6S ESC
• 1 x silicon grommets
• 1 x wire harness for F7 Flight controller